R/C Tech Forums - View Single Post - Houstons Engine Service H.E.S.
Thread: Houstons Engine Service H.E.S.
View Single Post
Old 01-07-2011 | 07:00 PM
  #4436  
teamlosi906's Avatar
teamlosi906
Tech Elite
iTrader: (235)
 
Joined: Oct 2009
Posts: 2,612
From: up michigan
Default
Originally Posted by bcr500
Hey Houston,im going to break in the engine that you modded for me a while back and was wondering if you have did these mods for anybody else.What i need to know is what kind of feedback you got from others as fare as low and high end performance,smoothness and fuel millage? Its a p5xlt with your mods,+4c crank,ceramic rear bearing and the front bearing you recomend.
I have the same one in truggy Sweet motor.Smooth power, Plenty of low end, and top end with a 9853 pipe 021 header,97t plug. I switched from a 50 tooth spur down to a 48 tooth and there is no other motor i ran against that could pull away on a long straight away. And lots of low end power still. Average run time almost 10 min.at 250 degree's. Favorite Motor.
teamlosi906 is offline  
Reply