Originally Posted by
BC slasher
well after 24 hours my center diff leaking again.it must be that im tightening the plastic spur down to much.my buggy is a conversion so its not new .ive rebuilt my diff 100 times over and never had an issue with anything.i slackend my screws a bit on c diff.anybody have any ideas why .i sanded it the other day and installed it again and seemed fine,but its leaking again.and man the stock motor mount really is a pain.
Where's your center diff leaking from? Is it an o-ring problem or a seal between diff case and spur problem? I usually have diffs leak because of the o-rings. Either use Kyosho o-rings or the updated Associated o-rings (which I hear are clear as opposed to black, but I haven't been able to find any yet).
The stock motor mount is good as long as you have good hardware (good washers and bolts). Flimsy washers will bend and cause your motor to shift. Also, I set gear mesh with the entire motor mount and center diff assembly uninstalled so it's easier to get to all the screws.