Originally Posted by
roychan69
Those aluminum 'roll-cage' will in fact damage your body even further as your polycarbonate will face the 'impacts' from the 'roll-cage'...
Cut holes in 'round-corners',
always, square cut-outs will caused 'splitting' upon impact, you can cut square ones, but the corners/edges have to be 'rounded'.
Use heavy-duty cloth duct tape, those grey colors ones you see at most hardware shops and DIY stores and tape them inside the body shell.
Hope it helps.
That's also another good idea. I actually have duct tape. My question is will the tape really work if the splits are already there???
I plain on just cutting a small whole in the window so air can get to the motor. I'm not going to do what I have done with the stock body and cut the whole window out. I'm Probley going to cut out the whole middle and leave the rest there so it will have the window as a brace.. once again thanks to all who have helped.