Had a very similar problem.. make sure u set it with the throttle in rev.. My m11 will do what u are saying if I don't set it this way.. then make sure u change the failsafe..
Cheers
Originally Posted by
Jack2
it just went full throttle as soon as the on switch was flicked without and input from the transmitter. steering was normal. that was my initial problem, just had a quick play with it, now It is going spastic its out of control. cuts in and out and glitches like mad, throttle that is. steering is normal, tried a new reciever, that didnt help, plugged a servo into the throttle port of the receiver and that was normal, soon as i plug the ESC in it does the same thing. I try and caliberate the neautral, full throttle, and full brake posions and it does all that, then it just goes nuts again.
I'm totally new to brushless and Lipo, last thing I ran was a Novak GTX in my trf 415 4-5 years ago.
I have a 2 in 1 program unit.
Also, its not the transmitter, because my nitro tourer and 1/8th scale cars are Fine, and as I said, i tried my new spare receiver in my 417, and same problems
the ESC initially did work A-OK, except for the running flat out for a few seconds once switched on. I'll double check the battery has plenty of power (SMC Cmax 5200, 50c+, Brand new)
cheers, thanks for your input