R/C Tech Forums - View Single Post - EB Mods JS Engine
Thread: EB Mods JS Engine
View Single Post
Old 01-04-2011 | 10:14 AM
  #1540  
quimby
Tech Initiate
 
Joined: Mar 2008
Posts: 45
Default
Originally Posted by EBMods
High Speed Needle: Flush with housing then 0.5 turn in

Low Speed Needle: Flush with throttle-arm housing then 1 turn in

Idle Screw: Carburetor Slide flush with the inside of the Carburetor, then turn idle screw in 1.25 turns (Air Gap will be between 0.7mm-0.9mm at this point)
As always thanks for the help Ed.
quimby is offline  
Reply