R/C Tech Forums - View Single Post - EB Mods JS Engine
Thread: EB Mods JS Engine
View Single Post
Old 01-04-2011 | 08:12 AM
  #1537  
EBMods's Avatar
EBMods
Tech Addict
 
Joined: Aug 2003
Posts: 526
From: PA
Default
Originally Posted by quimby
Could someone refresh my memory on the stock needle seetings for the .21 fully modded JS? Thanks in advance.
High Speed Needle: Flush with housing then 0.5 turn in

Low Speed Needle: Flush with throttle-arm housing then 1 turn in

Idle Screw: Carburetor Slide flush with the inside of the Carburetor, then turn idle screw in 1.25 turns (Air Gap will be between 0.7mm-0.9mm at this point)
Last edited by EBMods; 01-04-2011 at 08:41 AM.
EBMods is offline  
Reply