Originally Posted by Randy_Pike

We can change all of that. I will look into the suggestions and pass them along.

We've already discussed a "per cell" voltage adjustment that the user can set. This would be say 3.2v per cell and this would then be affected by the onboard interface as well. So 4 led's at 3.2v per cell would net = 12.8v,etc,etc

Timing really depends on the setup in question. For the T8 line I've found no reason to go above 50 but have gone all the way to 100 in testing. Some motors respond better to timing, mostly the wye wound motors like the 1900.

I often find gearing to be more of first adjustment rather than timing.

I have written a few "guides" for our tech department and support departments. I'll work on getting them put together into one doc and get the web guys to post it up.

Most of the info you're all looking for is in the update "notes" on the website.