R/C Tech Forums - View Single Post - TT-01 Forum
Thread: TT-01 Forum
View Single Post
Old 12-30-2010, 02:03 PM
  #1920  
Starteur
Tech Adept
iTrader: (1)
 
Starteur's Avatar
 
Join Date: Jan 2008
Posts: 242
Trader Rating: 1 (100%+)
Default

I am running a TT01 Type E with thw reinforced uprights.

I am trying ball studs with longer threads, I think that is the problem.
The ones I just installed, the threads portion is flush with the bottom of the uprights, so the upright is filled with the threaded portion of the ballstud. Because regular ball studs, the threads portion is only halfway into the upright, then when you hit the board it applies a lot of pressure on the ball stud and the weaker link is the upright so the hole becomes oval and then breaks.

I think I just solved my problem by analyzing it!

I'll let you know, my next race is the 16th of january.

Starteur
Starteur is offline