Originally Posted by
addicted2blue
I've ordered some of those option parts& car aswell (except the DF03 heatsink bar set&M-chassis rein. freewheel set) but also:
M03 universal set,M05 ball diff,M05 salu steering set,M06 rear alu upright (2°), M06 titanium screw set, the Alpine body parts set, a set of M&S-g
rip tires and some Hex head 5mm ball connectors.
And offcourse also a ESC.
I only need some 5mm alu wheel hubs.
All of the items did cost me (including shipping) over USD$400 and hopefully it's worted
and it should arrive next week.
I have all those new except M06 rear alu upright (2°) and titan screws. Bet i have enough over from M05 to use on M06. I wrote it by memory and no parts infront of me. Only reason to buy the reinforced freewheel set is that i suspect a bent rear axle on my M05. The reason for buying 4mm wheel hubs is that i find the car better to drive with a little smaller track. I used to try to get it as wide as possible before with Tobee 4mm offset axles, when i changed to 4mm the car was sorted!
With the M06 i have all M-chassis from Tamiya. In total 1x M01, 2x M02, 4x M03 (with a couple of R's), 1x M04 and and 3x M05Pro's (1 blue edition).
All cars are maxed out on options, like i do all my cars, nothing is saved. It's as much a pit race as a race on the track...
And good luck Calvin on your build!