Originally Posted by
AverageRacer
Ive been trying to find pictures of the hillbilly link on here can someone lead me to one
thank you
Originally Posted by
Drew Ellis
Sorry I looked for a picture and could not find one. I'm not running that link anymore. But if you want to try it you will just need some longer turnbuckles like 35mm. The link mounts to the top of the castor block like the stock one, but the link on the tower goes to the alum. part where the shock tower mounts. You just don't run the bottom screw for the shock tower. Use a pivot ball that has a screw on it and thread it though the bottom of the alum. mount. And that is the Hillbilly link. Hope that helps. A pic would of been easier.
Thanks Drew
Here you go. It's post #311 from page 8
Originally Posted by
Fred Hubbard
You can use the stock open balls ends that come with the car and the XRAY ball studs mentioned in Robbie's post. For using any of the XRAY ball cups I found it necessary to dremel about .5mm from the underside of it in order for the link action to move uninterrupted. See the attached image.
EDIT: My apologies for the size of the pic!!!
Last edited by Fred Hubbard; 12-17-2010 at 09:10 AM.