After more guess and test sessions at my local carpet tracks this is where I currently sit with my setup.

I am very interested in finding out what others have found out about this car to improve it's feel on carpet.

Driving Feel:
-A little pushy and lazy on corner entry.
-Tight through center.
-As I race stock my setup is built to maintain highest mid-corner speed.

Largest Improvements (Order Of Magnatude Improvement):
Adding lots of droop improved the car everywhere.
Going from 25wt oil to 40wt oil in the front end. (drastically kills the steering).
Moving the steering bell crank to the rear most position.
Moving Shocks front to #2 and rear to #4
Shimming the front end out to the max. (reduces traction roll)




Here it is:Front
Trackwide front 190mm
Rollbar front:1.4
Toe angle front: 0deg
FF Hingle Pin Mount:1.5-2.5 < >
Mount shim: none
5mm shim on inside bulkhead hole.
0mm shim on c-hub.
Front axle: Spool
Camber front: 1deg
Ride height front: 5.5mm
Caster front: 3 degrees
Downstop: 4mm over ride height (lots of droop)
Steering system: single (plastic stock one)
Ackermann: inside position and rear position on topdeck
Shock position front: Lower arm outside position and hole #2 on tower
Tires front: Jaco Blue (32 shore)
Traction Compound: Niftech Inside 50% tire
Shocks front : Stock with 17.5lbs losi spring using 2 holes and 40wt oil.


Rear:
Trackwide:186MM
Rollbar: 1.1 or 1.2
Toe angle -3
RR Hingle Pin Mount: 1.5-2.5 ><
Mount shim: None
RF Hingh Pin Mount: down and down
Camber: -2
Ride hight: 6MM
Down stop: 3.5mm over ride height
Rear hub: Wolf Hobby 1.5deg
1mm shim on inside bulkhead hole.
0.5mm shim on middle rear hub hole.
Shocks front : Stock Shocks with 15lbs losi spring using 2 holes and 25wt oil.
Shock position on tower: Hole #4
Shock position on lower arm: outer position.
ESC: Tekin RS, Throttle Profile 4, 5 drag brake, Stock Mode.
Motor: Trinity Duo2 17.5 full timing 4.12fdr
Tires Rear: Jaco Blue (32 shore)
Traction Compound: Niftech 100% tire
SMC 5200MAH 50c Lipo
Mazda Speed 6