Yes you can only not on a form as for some reason it won't work for me
Here it is:Front
Trackwide front 186
Rollbar front:stock
Toe angle front +1
FF Hingle Pin Mount:1.5-2.5 ><
Mount shim: none
1mm shim on bulkhead underneeth turnbuckle front
reduces sidebite
Front axle: Spool
Camber front: 0
reduces sidebite
Ride height front: 5mm
Caster front: 3 degrees
Downstop: -1
Steering system: single K-Factory
Ackermann: outside position and on topdeck rear position
Shock position front:Lower arm outside position and on tower also
reduces sidebite
Tires front: LRP CPX no tire tracktion applied
reduces sidebite
Shocks front are Top Photon with TM 1.4 springs and 3 holes and 600CPS oil.
Rear:
Trackwide:190MM
reduces sidebite
Rollbar: None
increases sidebite
Toe angle -3
RR Hingle Pin Mount: 1.5-2.5 <>
Mount shim: None
RF Hingh Pin Mount: ^^
Camber: -3
increases sidebite
Ride hight: 5.5MM
reduces sidebite
Down stop: -3
Rear hub: K-Factory 1.5 degrees
3mm spacer under turnbuckle on bulkhead on the inner position
reduces sidebite
Turnbuckle position on rear hub: Inner position
Shocks Rear: Top Photon with TM 1.3mm spring 3 holes piston and 600CPS oil
Shock position on tower: Inner hole
increases sidebite
Shock position on lower arm: outer position.
ESC: LRP SPX SS Mode 8,no drag brake and no auto brake
Motor: GM13.5 stock spec,no timing.
Tires Rear: LRP CPX tire traction on full tire
increases sidebite
Robitronic 5000MAH 40c Lipo
Body Dodge Stratos.
Hope this is to any use for some one as i have often heard that am way off what normally is used.
regards Roy