R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 12-09-2010 | 01:14 PM
  #13078  
Maximo's Avatar
Maximo
Tech Champion
iTrader: (11)
 
Joined: Jan 2005
Posts: 7,901
Default
Originally Posted by deadmancourt
so if you turn down the head button by lets just say .2mm....you would have to remove .2mm of shim to get the same trapped compression ratio...right?....im sorry neal..im not arguing..just very interested....i am a MACHINIST, and i run C.N.C MILLS and LATHE'S...so i am just wondering...thanks neal
I am cutting the squish band of the button...making the button a smaller volume.....i then have to adjust the shims for proper clearance
Maximo is offline  
Reply