I am currently running my Blitz in the Short Course Mod and Short Course Super Stock classes. I have a novac havoc pro ballistic 10.5t for the Mod and the same motor in a 13.5 for the Super Stock. I have just been running the 13.5 in both classes because there isn't enough time to de-solder and re-solder the connections in the 1 race gap between the two classes. I am wondering if it would be alright to use the single wire connectors for each of the three motor wires so I can just pull the two motor screws, pull the wires, and vice versa to swap motors between races. Any advice would be much appreciated.