Originally Posted by
biz77
How are you guys setting droop on the new front?
I'm currently using a single ride height gauge (going to purchase another) and placing directly in center at front of chassis at .5mm (or whatever the desired droop is) higher than my ride height setting. I then adjust the droop screws until tires on both sides just touch the ground. I figure one gauge on either side will give me a little more accuracy.
Originally Posted by
20 SMOKE
use two ride height cauges and measure the movement over the ride height
Yes, as 20 SMOKE has said use two (stepped) ride height gauges at each of the corners on the front end of the chassis and continue to do it the way you have described. Pretty stinking accurate this way.