R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 12-02-2010 | 05:17 PM
  #1030  
UltegraSTI's Avatar
UltegraSTI
Tech Champion
iTrader: (20)
 
Joined: Jul 2005
Posts: 7,171
Default
DO NOT REAM!!! if u get a really tight 1 then u can heat up the hingepins with a heat gun nice and hot then shove them in the arm and/or block and let cool. can warm the arm/block slightly too. the plastic will cool down much faster than the pin and it'll stretch just that fraction to free a bad mould/bound unit. otherwise...run it in.

R
UltegraSTI is offline  
Reply