SOLD
The is a very nice used Hot Bodies D8 Nitro Buggy!
It has had about 2 gallons on it and is in very good shape. The chassis has the usual signs of wear but is not thin. The car rolls super smooth.
Here are the details:
M2C Outer hinge pins installed
DE Racing mud guards
23 Spline aluminum servo horn
Spare rear shock tower
A set of practice tires
New packaged yellow 68mm rear springs
New packaged white rear wing (I was going to dye it)
New packaged air filter assembly
New packaged clutch bearings
New packaged rear hubs
New packaged front spindles
New right front carrier
Used spare front bumper
2 New front side of case halves
Throttle/Brake horns 23/24/25 spline
New DE Racing rear skid plate
2 Spare CVD's (1 used, 1 new)
New packaged universal joint rebuild kit (I used 1 of the 2)
New spare front A-arm
New spare rear A-arm
Used body, ok for practice
Used flywheel, shims, clutch bell, springs and shoes, all in good shape.
Here are a couple of other things to note:
The front shock tower has a small bend on one side. Not a big deal but you should know.
The front center cvd is due for a rebuild.
Needs body clips.
Chassis has been open up around the flywheel hole, just a little.
Electronics and motor are not included, it is a roller only.
Only possible trades for a Mugen MBX6
No other offers.
[email protected]
