R/C Tech Forums - View Single Post - Power tool bits ( cordless screw driver)???
Old 11-24-2010, 07:53 AM
  #8  
marshon50
Tech Fanatic
iTrader: (6)
 
marshon50's Avatar
 
Join Date: May 2006
Posts: 898
Trader Rating: 6 (100%+)
Default

I have the Ofna kit mentioned and also bought hudy 2.0 and 2.5mm. At first all I could do was praise the quality of the Hudy, but after time they're worn also. I'm actually using my Ofna 2.5mm driver more now because the Hudy was used sooo much. Dremel and a cutoff wheel are must haves too......when the edges aren't as crisp, just take off a couple mm and they're back to like new....this goes for any and all manufacturers. So for my money I'll buy the least expensive one knowing they'll all wear over time.
marshon50 is offline