Originally Posted by
dj apolaro
You do not use a bearing on the top at all. Just in the chassis. The red top is what holds the brake cam in place. Then the lever over that and all should fit and be good. I do not have the manual in front of me, but that is how it should be off the top of my head. I will check the manual later.
DJ Apolaro
Thankx for the rep dj.
The manual I received have the bearing part. Even a note that says "Insert ball bearing 5x8x2.5 in the botton side of the 2 part". The 2 part is the plastic one.
And the kit came with four bearings with this size, two for the rear wire anti-roll, I was guessing the other two for the brake assembly.