R/C Tech Forums - View Single Post - 8T 2.0
Thread: 8T 2.0
View Single Post
Old 11-18-2010 | 05:58 AM
  #10199  
pballer2777's Avatar
pballer2777
Tech Master
iTrader: (28)
 
Joined: Jan 2009
Posts: 1,854
From: dirty jerz
Default
Originally Posted by khannibal
I've got a totally noob problem!

I got the aluminum rear hub as a hop up. However, I am having difficulty disassembling the stock hubs from the dog bones, pins etc. Could anyone give me some guidance on this? I would like to use the parts from the stock hubs and transfer them to the aluminum ones - I am new to the hobby and I have been following the manual but it's still not clear to me.

Thanks in advance!
there is a set screw in the center of the axel. loosen that and then u can take the pin out that holds the hex on.the u can puch the axel through the bearings.
pballer2777 is offline  
Reply