Originally Posted by
DLS II
The front end and all 4 rims are from an Associated RC 300. I had the front sus. arms milled to get some movement. I don't know how well it will handle impacts. The rear end is from a Mcallister 1/10 speedway car. I made the chassis out of .125 G-10. It weighs 4.5 lbs. Don
Would you be interested in a set of hubs that will fit a modern 1/8th wheel?
I'm thinking of designing the hubs for my own pan car should I move forward with it. I will most likely bore a couple sets for the 1/4 inch axles and then some for a larger axle which I will be opting for.
I'm actually considering a gear diff instead of the standard ball style due to the power loads and additional dirt on the big paved tracks. Not quite sure which way I'll go, maybe just a larger thrust bearing design.