Originally Posted by
mjk1210
check the savox servos out. There are two models that are about $70. Both have metal gears. One is .07 transit time with about 140 oz/in of torque and the other is .08 with about 165 oz/in.
These are really impressive numbers for the money. Either one would get the job done for a 4wd buggy but as long as you're bashing I'd go with more torque
mjk, I just picked up a Savox servo for the 2wd buggy I'm building (factory team B4.1). I got the "low profile" one (SC1251mg, I think). Would you happen to know how it should be setup on the buggy, as far as spacers, etc. go? It's not listed on the servo chart in the instruction manual, and it's been about 15 years since I built a car outta the box.
thanks, dvd