I have some questions, and this sure looks like the place!
SC10 w/ Cirtix short course master setup, w/ included program card and 3600kv motor. Purchased from Shawn Palmer, new, about 6 months ago.
22/87 gearing, temps good, performance good.
Works great in competition, but.......
DRRS maxed out, Timing maxed out, Torque limit maxed out,( 0% limit).

What are the software upgrades available?
What performance increases can be obtained?

Removed the 3600kv SP motor, installed a Venom 10.5/4200kv/540,(temporarily), to try to get more all around perf. increase. 22/81 gear, temps good (esc & motor),timing maxed out, DRRS maxed out, Torque limit @ "0%".
Kinda "BLAH", better, yes, but does not run like other Venom motors I have,

IS the ESC the culprit?
What am I missing here?
Thanx to all.