Originally posted by InitialD
Ok. Is the end result very tight? But I thought that the loosest setting was still too tight already ! I'll try again.
Pay attention on your 802310, with standard pulley it touches the belt already. You need to files it a bit. I think Mr Jack (clmb45) already mention it before.
Originally posted by InitialD
The part where the screw comes out to tighten the clamp, rubs and touches the side of the diff housing holder.
Still not sure about this, have to check my car tonight.
Originally posted by InitialD
So you just install the rear diff without the diff adjustment clamp? Install the diff like installing rear diff on the orginal 705?
Correct.