Originally Posted by
Magneto
Just tried to update like you said, but i still get the error as soon as i hit the update button. When i close the error screen it's followed by a small blank window with no text and just an "ok" button.
I think update program can write to the esc because i successfully updated from ver 1.1 to ver 1.3
But i doubt the novalink software can.
Just to make sure, check that your cable is plugged into the NL with the right polarity, there is a small black pen mark on the NL and this should be the black wire of the speed control. Check that while I ponder for a bit.
Also do you get the "connected" message on the upper right hand side of screen when you are connected to the speed control?