My track has a 35m straight with a shorter 20m straight infield with sweeping corners...
I cant remember my exact settings but from what i remember is this: -
FDR = 7.35
9 = 5
12 = 4
13 = 5
14 = 4
15 = 6
after 7 mins runs... competitively
Motor temps 50 degrees C...
Ambient = ~ 29 - 31 C
Both mine (X12 10.5T stockspec) and Xerun 10.5T shows the same temp
Originally Posted by
hardmankam
Hi there, I run a similar setup as you but with a much lower motor temp.
My settings are:
FDR: 7.6
SW:518Stock
#4:7
#9:6
#12:4
#13:6
#14:4
#15:6/7
straight is 35m long, with semi-technical infield.
outside temp: ~ 22C, track ~ 35C-40C
motor temp after 6 mins: ~ 60C (x11, 10.5r, Zero timing)
It looks like your motor is quite hot. Check your pinion & spur gears to make sure they are not binding. Make sure your transmission is also smooth. Are you running any motor timing?