Originally Posted by
Skiddins
If I understand you mean to deliberately run them the wrong side of the car.
With or without the writting down?
Do you have any photo's to show exactly what you mean.
Skiddins
No the H1 goes on the left and the H2 goes on the right. With the writing facing up.
Originally Posted by
FLAT OUT
If you are running them on the front it is H1 left H2 right
Yes thats right.
Originally Posted by
4j's
hi fellas need your advices.
I have xray t2008 (quite old model bought this two years ago, then took a rest from playing rc, never have chance to assemble the said kit )
Now im trying to carve my way in by assembling the kit.
I have asssembled the car based on the manual recommendation.
installed the "diff pully 38T (rear and front)" , "fixed pully 16T" and "spur gear 84T (48 pitch)"
Now my question is what
pinion T should i install to match the said combination or, what is the best FDR if i am tending to use 11.5T brushless motor?
Your advise would be appreciated
Thank you
I would think about starting out around a 7.00 FDR.
Thanks Drew