Originally Posted by
scurr
Just the standard shims on 25%
Think i may of mistyped my issue... The screw that holds the clutch bell in, can it be spun threaded?? as the screw came out even tho it was tight as hell (bell could spin freely tho)
I had one come loose once and now i put a SMALL drop of blue locktight on the end of a small zippy tie and carefully stick it in the end of the crank shaft and wipe it on the tread, this works better than putting it on the screw as there is no chance of the locktight getting on the shims/bearings.