R/C Tech Forums - View Single Post - One way bearing question.
Thread: One way bearing question.
View Single Post
Old 10-25-2010, 12:38 PM
  #2  
jwm2
Tech Fanatic
iTrader: (5)
 
jwm2's Avatar
 
Join Date: May 2010
Location: Grand Rapids, MI
Posts: 823
Trader Rating: 5 (100%+)
Default
Originally Posted by marooko
Total nitro noob, please go easy.

I have an RTR RC8 with the .28 engine. If the one way bearing goes out, I will not be able to start via roto-start or bump box, this correct?

Also, I looked for a pull start, but can't find one. Not sure if I'm just not searching correctly or what. Any info on this would be greatly appreciated.

Thanks, folks.
You shouldn't have a one way bearing if you are using a bump box. Roto start is another story, it may have a one way bearing. If you are planning on using a bump box, i'd get the correct backplate and that way you don't have to worry about a one way bearing at all.
jwm2 is offline  
Reply