Originally Posted by
radio_car_racer
Grip Roll & the New BMI Front End
anyone found/finding grip roll has reduced when using the NFE or is it still there?
When i was testing the front end, i tested many different roll centers and camber curves and settled on what we have. With the hinge pin block lower than the stock supplied hardware, we had allot of traction roll issues. Once we raised the hingepin block to where it is now, the car never even came close to traction rolling. So i really dont think you will run into any problems. Im sure that if the setup is way off you can get it to roll over but it is very easy to tune it out.