Old 04-08-2004, 01:51 AM
  #2  
g_bruin
Tech Adept
 
Join Date: Jan 2003
Location: So. Cal.
Posts: 157
Default

If you look at the picture, the top left corner is the cutting part. Turn the bit 180 degrees so that it is facing down and to the left and have it facing the armature. That way it is the first part to touch the comm as you move from right to left. Make sure the armature is spinning upwards.

Don't forget to shim it so that the cutting tip is .15-.20 above the v-block. I measured it by using the .20 shim and placing it between the cutting bit and v-block. If it fit then I know I had the right clearance.
g_bruin is offline