Originally posted by tamiyadriver
well, maybe these were the rear. they come as a set. here is a pic:
the F201's wont work, i dont think. those of you with them will notice that the inner bearing is huge... like the diff bearings. havent looked at the rear yet, tho... figure its the same. in this pic i have a set of unknown MIPs. might work, except i have to use a spacer between the cv and the inner bearing... not sure how that would affect the geometry...
All you have to do is use the F201 48mm shafts and the origional 415 cups then you have a longer drive shaft
