R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-18-2010 | 10:05 PM
  #596  
racer1812's Avatar
racer1812
Super Moderator
iTrader: (31)
 
Joined: Nov 2008
Posts: 15,739
From: RIP 'Chopper', 4/18/13 miss you bud:(
Default
Originally Posted by Anthony.L
Follow the instructions and you will be fine. Set your rebound at approx 3-5mm.

Biggest key to building the shocks is make sure the shock shaft does not pull out while tightening the bleed screw. If it does it will draw air into the shock. You will need to bleed the screws a couple times, one time will not be enough.

Also pour some shock oil in the cap before screwing it on the body.

P.S. These are my favorite shocks I've ever built (ok well at least tie Xray's TC shocks).
Awsome shock IMO, you all realize you can not remove 100% of the air in the shock with the piston and shaft pushed up, if you do you will create a vacuum in the shock and when you pull the shaft out it will actually suck back in.
racer1812 is offline  
Reply