Please Help!
I have a few questions if someone would help that would be greatly appreciated:
1. If I install the Tamiya 54121 Aluminum Servo horn will this take out the slop in my servo saver? Do I have to buy the new servo saver and the horn or will the horn alone fix the slop? I'm guessing the slop is caused by the soft plastic top piece being compromised by the servo saver springs in a good impact.
My servo saver is notchy and causes my car to wander left or right.
I know a lot of you use the Kimbrough servo saver too, but would prefer to pickup the Tamiya aluminum horn since it is locally sold.
2. Are the knuckles and c-hubs left/right specific?
3. My car has some torque steer. There is no tweak but I have yet to balance the chassis, could this cause the on/off throttle torque steer?
BTW, I am running Jilles asphalt setup on the car, 21.5 Novak, 50c Thunderpower battery, 15g weight on battery side rear, Havoc ESC and S9551 Futaba Servo with R604fs receiver.
Thanks a lot in advance.