R/C Tech Forums - View Single Post - Dynamite Platinum or Werks B6
View Single Post
Old 10-13-2010 | 07:39 PM
  #48  
Werks
Tech Elite
iTrader: (3)
 
Joined: Jan 2007
Posts: 3,769
Default

Originally Posted by JAMMINKRAZY
Just buy an OS and be done with it!

Yeah, I'll be THAT guy.
Lol, well then let me be the guy that tells you that last week at the practice session in Thailand in Kortz's car our stock B6 with a simple ceramic rear bearing had more bottom, mid and top end than the guys running the new OS Speeds. And this is at an event where everyone knows how to tune an engine properly and they can all drive correctly so no mish mash of boy racers and local track trash talkers. Plus I might add we were getting 10:38 seconds a tank run time with a stock 7mm reducer to boot. Roughly 15 to 20 sec more than what I was clocking others at. As they say talk is cheap, facts don't lie and if you want facts then you need to compare the performance of engines back to back on the same track with people that can drive just as fast. In a nutshell everyone that is probably going to make up the a-main at the worlds was there, so you can't get any better drivers to use to make a comparison with. As far as the OP's question about a comparison to Dynamite I cant say as I did not see one running there. There were some guys running alpha but they were so far off the pace that it was not possible to make a comparison as far as engine performance is concerned.
Werks is offline