R/C Tech Forums - View Single Post - Factory settings Novamega SX12 SS?
View Single Post
Old 04-05-2004, 06:41 PM
  #17  
AMGRacer
Tech Elite
 
AMGRacer's Avatar
 
Join Date: Oct 2001
Location: Brisbane, Australia
Posts: 3,939
Default

Originally posted by fmolzer
NS3 .12:s I just checked the one engine I have left that is not even broken in yet, it acctualy ahs a low end needle setting of 1.75 turns from fully closed. These are all hand modded Novamax engines, but I would not ecept them to be that much different??? My NovaMega .12 really, really did come with the low end needle at 0.75 tuns out. hmmmm. 3.5 certainly sounds very, very rich to me, but it appears that there are some variations here. I checked the Novamax that was n my car during winternats, and it has a lowend of 1.75 turns out and I know that worked on the track for a fully broken in engine.
You could be right. At the factory the needles are set with a flow bench so each carb may be different.

Check this: http://www.teamtrinity.com/tips/nitro.asp

In any event here is the "official" info from the Trinity site:

Novarossi NS12XX or RS12XXXX (General Carb Settings)
Low Speed: 3.25 turns out
High Speed: 4 turns out
Mid-Range: Flush with the carb body
AMGRacer is offline