Originally Posted by
jmaxey51
IMO i would go with the Red Head Alpha which is 30 bucks cheaper
almost the same exact thing. i know Alphas take close to two gallons to break in fully. when breaking them in, make sure to use a heat gun and get it up to about 180-200 before even crank it. idle 6-8 tanks at around 190-200 degrees and youll be good.
http://www.championrc.com/cd/ARCBT5P...d-motor-5-port
BUT imo the green head Alpha is better for buggy, and its still 20 bucks cheaper than the Dynamite engine...
http://www.championrc.com/cd/ARCBT52...d-(speed)-5+2P
On my Dynamite break in i got a lil over a half of a gal on the exp and with plug out i sitill have a little resistance, so im not 100% past break in but with plug in its got a butt load of resistance but i dont need a heat gun to crank it now. I just raced it friday with 2053 and loved it. I ended up actually winning and coming off a 10 min race at 207, it had alot of power and the pipe did good, im sure another pipe will do better but i got 7+ mins on a tank still running really fat considering once i get about another 3/4 gallon through it i will see what it does at about 240. Not ganna go 250 which is what alot of people say run it at but im confadent that i found my engine im ganna stick with and thats DYNAMITE! Alpha also very nice i might try it next.