Originally Posted by
Duster_360
Two of these would be equiv to a 1600mah hump pac.
Originally Posted by
Duster_360
Prob 1st thing to do is to tape or glue the two cells together with the ends reversed to each other - neg and a pos at the same end. I use shoe goo since its strong, dries pretty fast and is easy to remove.
Then take some 16-18ga wire and connect the 2 cells neg to pos on one end. Use a servo extension and cut the fem end off and solder the remaining ends to the correct ends of the two batteries. Red is pos.
Connecting those batteries together in series as described will create an 800mah, 6v pack. In order to make a 1600mah 6v pack, he'll need 4 of those set up in 2s2p configuration.