mmm the 3pk has two switches. One on the left side of the screen which only turns on the screen. To turn on the radio part hit the switch on the right side of the wheel.

To bind:

" to bind, turn on your TX (transmitter) and then your RX (reciever) the reciever will light up RED, next to the RED light there will be a little button. with the TX close to the RX hold down the button untill the light turns GREEN, once the light is GREEN the programing if complete.

to set the failsafe PERMANETLY you must be running in HRS mode which requires the use of digital servos (stock servos are analog)

If your running in PPM mode you will have to manually set the failsafe evertime by holding down the F/S button located on the back of the TX. to set, turn on your TX and RX, apply the brakes then press the F/S button, release and then shut off your TX. when you shut off your TX your brakes should still be applied letting you know the failsafe is working. then turn on your TX and your ready to run with your failsafe enabled."

(Taken from http://www.hpibajaforum.com/forum/sh...04&postcount=3)