Originally Posted by
inconceivable
Tony - I have one of these but the instructions leave a little to be desired. How do you wire this up ? I get that the end with JST connector goes to the receiver, but how do you wire the other end (to the battery I suppose ?). I'm using a Tekin RS if that matters. Any insight is appreciated.
Thanks,
Mike
Get a servo extension, remove the white "signal" wire, cut the socket end off, and solder the red and black wires to the B+ and B- posts on the RS. Plug the other end of the extension into the booster, with the black wire on the same side as the black coming out of the voltage booster.
As soon as you plug your 1s LiPo in, the entire system is on.
I soldered a switch inline with the red servo extension wire so that I can turn the voltage booster on/off.