hey guys a note on the rear swaybar..the collars that go into the bearings on the bulkhead that hold the sway bar, well one side of the collar has an opening so it can make the bend on the swaybar to go on and off, well there is 2 sides u can put the set screw u have to check this for some reason when u put the set screw in one side it sort of bends the collar out alittle bit and the collar dont sit perfectly flush against the bearing and in turn will tweak the sway bar so check if the collars are flush if not remove the set screw and put it into the other side it has something to do with the opening in the collar. also note make sure the sway bar is even on both sides of the collars as it will also cause a tweak on eaither side....