Originally Posted by
kai888
hey guys, just a quick question regarding the carb, have issue where sometimes it gets stuck and not return back to the closed position, the servo is still buzzing trying to move it
if i'm sliding it with my hand it feels very rough compared to the carb on my axe rossi motor which is very smooth.
is this because its new or have i got a dodge carb?
thanks.
Your linkage wasn't pulling it at an angle instead of straight out was it ?
or
When you pull the trigger on your radio can you still pull the slide out another 3mm from full trigger ie; you haven't over extended it at some stage ?
or
The grove in the slide for your idle screw may have a bur on it.
Check these three things