R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 10-03-2010 | 10:15 PM
  #12195  
inferno13
Suspended
iTrader: (202)
 
Joined: Dec 2009
Posts: 7,916
From: northern michigan
Default
Originally Posted by deadmancourt
YES THE ROD WILL FIT ALL MODELS!..21,25 AND 28....the reason why he snapped a rod is cause he DID NOT break it in right OR PRE HEAT it while it still has LOTS of pinch!....when a motor is new(regardles of the brand) you want to ALWAYS pre heat the engine before you run it because when fired cold you are just abusing the hell out of the rod,because the piston is still trying to form the sleeve!.....
NOPE. he was on his lid and was at WOT for 20 seconds. lol, alway trying to blame it on tuning....lol
inferno13 is offline  
Reply