Originally Posted by
the_winner
the engine he will give it to me for 20$ bucks ..
It need a new crankcase and carburetor pinch bolts
maybe i will make it from gx7r to gx5r with changing the piston-sleeve ...
the crankshaft at the crankshaft pin has loose the tin coating ... i must change also the crankshaft ?
Also which is the best pipe?i have a pipe set from my nova 9901 with 41021 header it will be good to use the same?i dont want to buy new GO pipe because i have not the money . I want just to fix this engine cheap.
I have found cheap the parts...
pinch bolts from Precirotate engines 6$
crankcase from ebay with bearings and backplate from gx5r 40$
also if i will make it GX5R i will need 80$ for p/r/s
so i will give 126$ for parts+20$ for the engine =146$ and i will have a new gx5r engine ...
Which cheap pipe set will be better? a dynamite 053 or a dynamite 086? or my novarossi pipeset that i have it already?
Thanks
086 pipe set. Check with motomatt on the parts. He might be able to get you the case cheaper then ebay, and the P/L/R combo cheaper also. If it was me, I would just replace the case if everything else is good, and run it with the 086 pipe. That is the pipe that seems to work wonders on any of the newer higher rpm engines. (from what I have gathered in my infinite research in the last few weeks)