Originally Posted by
JBM Racing
Boost set to max and timing starting at 4000RPM, if I was using the Novalink software what end RPM should I use?
When programming using novalink, we currently set the end rpm to the recommended 2500 stagger for 10.5 , (a larger stagger is used with a different profile for the lower winds).
The full timing will be applied at 6500 if start is set to 4000, this gives the car chance to start the lift from the corner on no applied timing other than the 30deg on the motor, as apex rpm's on tight hairpins are usually about 2500/3000 , once the car is exiting the corner the dynamic timing is being applied and is fully in by 6500 rpm, the car will have lots of rip, even on short straights, ie indoor.
Steve