Originally Posted by
Gitsum
Well are they the same? When you put a cvd and a newer cva next to each other are the pin holes in the same location and is the length of 2 the same? Were you able to shim them the same to fit properly? thanks!
they better be the same, I just switched them out as I'm getting the car re-done for the indoor season. Whole new trans, outdrives bearings and CVA's instead of CVD's. they shimmed the same.
My plan is to change parts as they wear out. I'll need to replace them at some point anyway, so I'll just buy the new versions when I do. I actually can't wait to put the new shocks on it though. I might have to push the car down a few hundred times on the pit table before each race to wear out the shock bodies a little faster.