Originally Posted by zrxrxr

For crying out loud. Any and every brand is going to have duds. Stop crying about it and switch companies if you are not having luck with one. Don't give us your sob story about how you always hook your connecters backwards or fail solder so the motor leads touch and you smoke equipment.


Honestly, if you have enough $$ to go through that many escs maybe you can figure it out. Then again having money doesn't make you intelligent.

Originally Posted by Storydude1

10,000 units shipped with a 1% failure means 100 bad units may have made it to the marketplace. Sucks when you get 5 of them in a row. Which, BTW, is statistically impossible.


Check something else in your setup. Something's not right.