Originally Posted by
MiniMeRCRacing
I have a pair of Muchmore RC setup blocks and ride height gauge but the ride height gauge is not tall enough to be of any help. The blocks are 20mm in height so I thought they were too small to use to figure out camber (since your suppose to push down on the chassis onto the setup blocks to get the correct camber setting). Am I correct to assume that I need 30mm blocks to use with the DM-1?
I see where the confusion comes in, and have the same difficulty understanding.
The Hudy 1/8
offroad setup station says to use 30mm blocks when checking and adjusting the Camber and Toe. The Hudy 1/8
onroad setup station manual does not use any blocks for these adjustments.
Problem is with GT type cars is what method of setup is the proper one?
I run the Kyosho Inferno GT. In addition to the Camber and Toe adjustments being different from On to Off road the droop measurements are also taken at different spots on the arms. I'm referring to the Hudy manuals only.
Its really confusing that we are setting up
onroad cars based on
offroad chassis' and using
offroad setup stations to set up
onroad cars. Sheeesh!! No wonder my brain is fried!!
