R/C Tech Forums - View Single Post - Team Grid Performance Parts Thread
Thread: Team Grid Performance Parts Thread
View Single Post
Old 09-18-2010 | 08:02 AM
  #5  
Team Grid RC's Avatar
Team Grid RC
Tech Addict
iTrader: (3)
 
Joined: Sep 2010
Posts: 644
Default
Originally Posted by slaytanic
I am very interested in a motor mount for my xray buggy and truggy. I am curious about the range of pinions that are usable with this design. It appears that it might have a limited range of adjustment. Could you comment on that?
Big question for you. What is your gearing and Lipo setup now?

Our one-piece motor mount is front pinion shaft supported means the pinion gear is required to be installed first onto the motor then passed through the mount to be bolted down. The GRID mount will physically allow the largest which is a 19T pinion.

We also have another motor mount being finalized that will allow 19T and beyond. This mount is rear pinion support and allows the pinion gear to be installed after the mount is bolted to the motor.

Does this answer your question?
Last edited by Team Grid RC; 09-18-2010 at 10:06 AM.
Team Grid RC is offline  
Reply