Originally Posted by
bboard
I was only temping the motor to make sure it isn't running way too hotm and I'm temping while the motor is still running. I was at 3/4 on top and 1 turn on bottom, and it was getting there. Running p3, Byrons30, and Dynamite 086. I gotta say that even with an off-tune this motor hauls especially on the bottom end.
bboard iv seen guys temp like a pit stop then let the engine idle for 30 sec and and temped again and it has already cooled 20 degrees very fast cooling at idle and shut off. thats what i was trying to tell ya. but just go easy with the needles you may find out by the time you find the sweat spot the low spead needle may be in alot further then you would think.